Flexy-Flyer Cardstock Model
Designed by Ron Caudillo
Ron Caudillo designed this realistic 1/10 scale model
that is cut from a sheet of 65# cardstock that was
printed using a color printer. All you need is an Xacto knife,
scissors,straight edge and a little Elmer's glue.
You can either click on the Jpegs below and then download the full size 8-1/2 x 11 picture or download two Adobe PDF'f by right clicking on the Adobe Icon.
Flexy Flyer model - page 1 & 2 (829K)
Flexy Flyer Instructions - page 3 & 4(463K)
Building the Flexy-Flyer model
Note: each of these .JPG's are about 1 MB in size so they will take a while to load.
Pictures Copyright © 2001-2002 Mike Konshak. All Rights Reserved.
Models Copyright © 2002 Ron Caudillo. All Rights Reserved.